SQ9S-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9S-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1781365628	64 Count	497 Count
1781363828	63 Count	490 Count
1781362027	62 Count	483 Count
1781360227	61 Count	475 Count
1781358432	56 Count	466 Count
1781356631	55 Count	452 Count
1781354831	54 Count	435 Count
1781353030	53 Count	407 Count
1781351230	52 Count	397 Count
1781349429	51 Count	382 Count
1781347629	50 Count	370 Count
1781345828	49 Count	360 Count
1781344027	48 Count	353 Count
1781342227	47 Count	340 Count
1781340427	46 Count	333 Count
1781338627	45 Count	324 Count
1781336832	40 Count	313 Count
1781335031	39 Count	298 Count
1781333231	38 Count	292 Count
1781331430	37 Count	282 Count
1781329630	36 Count	275 Count
1781327829	35 Count	267 Count
1781326028	34 Count	257 Count
1781324228	33 Count	246 Count
1781322427	32 Count	239 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)