SP1KAM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KAM. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temperatura CPU*	Obciazenie CPU*
1781967001	55 Deg.C	2 %
1781966404	55 Deg.C	2 %
1781965802	55 Deg.C	2 %
1781965205	55 Deg.C	2 %
1781964602	55 Deg.C	2 %
1781964005	55 Deg.C	2 %
1781963402	55 Deg.C	2 %
1781962805	55 Deg.C	2 %
1781962201	55 Deg.C	2 %
1781961605	55 Deg.C	2 %
1781961002	56 Deg.C	2 %
1781960405	55 Deg.C	2 %
1781959801	55 Deg.C	2 %
1781959201	55 Deg.C	2 %
1781958605	55 Deg.C	2 %
1781958002	55 Deg.C	2 %
1781957405	55 Deg.C	2 %
1781956801	55 Deg.C	2 %
1781956205	55 Deg.C	2 %
1781955601	55 Deg.C	2 %
1781955002	55 Deg.C	2 %
1781954405	55 Deg.C	2 %
1781953802	55 Deg.C	2 %
1781953205	55 Deg.C	2 %
1781952602	54 Deg.C	2 %

*Used Equation Coefficients:

Temperatura CPU: 0, 0.1, 0

Obciazenie CPU: 0, 1, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)