PD2ATG-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2ATG-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1757539739	5 Count	38 Count
1757537938	5 Count	38 Count
1757536138	5 Count	38 Count
1757534338	5 Count	38 Count
1757532538	5 Count	38 Count
1757530738	5 Count	33 Count
1757528938	5 Count	22 Count
1757527138	5 Count	12 Count
1757525338	5 Count	7 Count
1757523538	5 Count	6 Count
1757521738	5 Count	6 Count
1757519937	5 Count	6 Count
1757518137	5 Count	6 Count
1757517921	5 Count	6 Count
1757516434	5 Count	6 Count
1757514634	5 Count	5 Count
1757511801	4 Count	1 Count
1757511657	4 Count	1 Count
1757511352	3 Count	1 Count
1757510723	2 Count	1 Count
1757510585	1 Count	0 Count
1757510510	0 Count	0 Count
1757509557	0 Count	0 Count
1757509375	0 Count	0 Count
1757509268	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)