4K6AG-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6AG-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787574506	597 Count	13 Count	13 Count
1787573904	596 Count	13 Count	13 Count
1787573295	595 Count	13 Count	13 Count
1787572688	594 Count	13 Count	13 Count
1787572087	593 Count	13 Count	13 Count
1787571483	592 Count	13 Count	13 Count
1787570877	591 Count	13 Count	13 Count
1787570273	590 Count	13 Count	13 Count
1787569671	589 Count	13 Count	13 Count
1787569063	588 Count	13 Count	13 Count
1787568459	587 Count	13 Count	13 Count
1787567859	586 Count	13 Count	13 Count
1787567253	585 Count	13 Count	13 Count
1787566649	584 Count	13 Count	13 Count
1787566046	583 Count	13 Count	13 Count
1787565445	582 Count	13 Count	13 Count
1787564842	581 Count	13 Count	13 Count
1787564238	580 Count	13 Count	13 Count
1787563635	579 Count	13 Count	13 Count
1787563025	578 Count	13 Count	13 Count
1787562415	577 Count	13 Count	13 Count
1787561812	576 Count	13 Count	13 Count
1787561211	575 Count	13 Count	13 Count
1787560605	574 Count	13 Count	13 Count
1787560001	573 Count	13 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)