SP2WRE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WRE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1780346293	248 Count	563 Count	9 Count
1780344491	247 Count	561 Count	9 Count
1780342689	246 Count	559 Count	9 Count
1780337282	243 Count	553 Count	9 Count
1780335481	242 Count	551 Count	9 Count
1780333679	241 Count	548 Count	9 Count
1780331421	236 Count	546 Count	9 Count
1780329620	235 Count	544 Count	9 Count
1780327818	234 Count	542 Count	9 Count
1780326016	233 Count	540 Count	9 Count
1780324214	232 Count	538 Count	9 Count
1780322412	231 Count	515 Count	9 Count
1780320611	228 Count	507 Count	7 Count
1780318810	227 Count	506 Count	7 Count
1780317009	226 Count	503 Count	7 Count
1780315207	225 Count	500 Count	7 Count
1780313405	224 Count	496 Count	7 Count
1780305900	218 Count	464 Count	7 Count
1780304098	217 Count	462 Count	7 Count
1780302295	216 Count	460 Count	7 Count
1780300492	215 Count	458 Count	7 Count
1780298689	214 Count	456 Count	7 Count
1780296888	213 Count	453 Count	7 Count
1780293284	211 Count	446 Count	7 Count
1780291483	209 Count	441 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)