SP8RPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8RPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1784619672	846 Count	700 Count	692 Count
1784533268	299 Count	236 Count	233 Count
1784502060	179 Count	144 Count	144 Count
1784454070	934 Count	808 Count	799 Count
1784348466	219 Count	201 Count	192 Count
1784319660	1001 Count	924 Count	884 Count
1784317259	975 Count	898 Count	860 Count
1784314857	953 Count	872 Count	840 Count
1784312455	928 Count	848 Count	817 Count
1784310053	908 Count	828 Count	799 Count
1784305264	871 Count	798 Count	770 Count
1784302862	846 Count	775 Count	747 Count
1784283664	708 Count	638 Count	629 Count
1784281261	693 Count	623 Count	616 Count
1784185250	842 Count	951 Count	691 Count
1784106052	429 Count	618 Count	360 Count
1784103650	417 Count	607 Count	350 Count
1784101248	405 Count	597 Count	340 Count
1784096445	366 Count	560 Count	305 Count
1784094043	343 Count	528 Count	286 Count
1784089254	277 Count	443 Count	235 Count
1784086852	244 Count	399 Count	206 Count
1784084451	219 Count	362 Count	183 Count
1784082049	193 Count	309 Count	163 Count
1784079647	166 Count	259 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)