DL7AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL7AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784680080	3992	40	62	1236	8080
1784679780	3992	40	62	1236	8080
1784679481	3992	40	62	1236	8080
1784679180	3992	40	62	1238	8082
1784678880	3999	40	61	1238	8080
1784678581	4000	40	62	1239	8081
1784678281	4000	40	62	1239	8081
1784677981	4000	40	62	1238	8081
1784677681	4000	48	61	1238	8082
1784677381	4000	40	62	1238	8081
1784677081	4000	40	62	1238	8081
1784676781	4000	48	62	1237	8081
1784676481	4000	40	62	1240	8081
1784676182	4008	48	62	1240	8081
1784675880	4008	47	63	1240	8082
1784675582	4008	48	62	1240	8082
1784675280	4008	41	62	1240	8083
1784674983	4008	48	62	1243	8083
1784674680	4008	48	63	1244	8083
1784674383	4008	48	62	1244	8083
1784674080	4008	56	62	1245	8083
1784673777	4016	56	62	1245	8084
1784673478	4016	56	62	1245	8084
1784673178	4016	56	62	1245	8084
1784672879	4016	56	62	1244	8083

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)