CT2IKC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CT2IKC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753618895	237 Count	402 Count	172 Count
1753617091	234 Count	397 Count	170 Count
1753613484	228 Count	387 Count	166 Count
1753611720	225 Count	382 Count	164 Count
1753609917	222 Count	377 Count	162 Count
1753608113	219 Count	372 Count	160 Count
1753606310	216 Count	367 Count	158 Count
1753604506	213 Count	362 Count	156 Count
1753602703	210 Count	357 Count	154 Count
1753600899	207 Count	352 Count	152 Count
1753599095	204 Count	347 Count	150 Count
1753597292	201 Count	342 Count	148 Count
1753595488	198 Count	337 Count	146 Count
1753593685	195 Count	332 Count	144 Count
1753591881	192 Count	327 Count	142 Count
1753590119	189 Count	321 Count	140 Count
1753588315	186 Count	316 Count	138 Count
1753586512	183 Count	311 Count	136 Count
1753584718	180 Count	306 Count	134 Count
1753582904	177 Count	301 Count	132 Count
1753581101	174 Count	296 Count	130 Count
1753577494	168 Count	285 Count	126 Count
1753573887	162 Count	274 Count	122 Count
1753572083	159 Count	269 Count	120 Count
1753570280	156 Count	264 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)