SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757503115	27 Count	69 Count	22 Count
1757501314	17 Count	48 Count	15 Count
1757499514	9 Count	24 Count	8 Count
1757497713	392 Count	1018 Count	321 Count
1757495912	383 Count	992 Count	314 Count
1757494112	374 Count	968 Count	306 Count
1757492311	364 Count	940 Count	299 Count
1757490510	354 Count	912 Count	291 Count
1757485122	326 Count	840 Count	272 Count
1757483321	316 Count	815 Count	264 Count
1757481520	306 Count	779 Count	256 Count
1757479720	295 Count	755 Count	248 Count
1757477919	286 Count	719 Count	240 Count
1757476118	274 Count	669 Count	231 Count
1757474317	267 Count	644 Count	225 Count
1757472517	257 Count	618 Count	218 Count
1757470710	248 Count	593 Count	210 Count
1757468909	238 Count	569 Count	202 Count
1757467126	226 Count	541 Count	194 Count
1757465325	217 Count	514 Count	186 Count
1757463524	207 Count	489 Count	179 Count
1757461724	199 Count	466 Count	172 Count
1757459923	189 Count	442 Count	165 Count
1757458122	181 Count	417 Count	158 Count
1757456322	172 Count	390 Count	151 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)