SP4WSL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4WSL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787573118	577 Count	821 Count	531 Count
1787571317	532 Count	746 Count	487 Count
1787569517	517 Count	725 Count	473 Count
1787567716	492 Count	694 Count	449 Count
1787565915	477 Count	671 Count	435 Count
1787564115	460 Count	647 Count	419 Count
1787562314	445 Count	625 Count	405 Count
1787560513	430 Count	602 Count	391 Count
1787558713	414 Count	578 Count	376 Count
1787557038	399 Count	558 Count	362 Count
1787555111	383 Count	537 Count	347 Count
1787553311	356 Count	500 Count	321 Count
1787551516	335 Count	465 Count	301 Count
1787549715	320 Count	443 Count	287 Count
1787547914	301 Count	414 Count	270 Count
1787546114	265 Count	360 Count	235 Count
1787544313	248 Count	336 Count	220 Count
1787542512	233 Count	310 Count	207 Count
1787540712	196 Count	256 Count	172 Count
1787538911	181 Count	234 Count	159 Count
1787537110	164 Count	213 Count	144 Count
1787535310	147 Count	191 Count	129 Count
1787533509	131 Count	170 Count	116 Count
1787531708	114 Count	151 Count	101 Count
1787529917	98 Count	129 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)