SP2KDS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2KDS-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789959860	11 Count	198 Count	5 Count
1789958060	9 Count	169 Count	4 Count
1789956259	8 Count	141 Count	4 Count
1789954458	7 Count	112 Count	4 Count
1789952658	5 Count	78 Count	3 Count
1789950857	3 Count	51 Count	2 Count
1789949056	1 Count	26 Count	1 Count
1789947256	91 Count	1024 Count	54 Count
1789945455	88 Count	994 Count	52 Count
1789943655	85 Count	963 Count	50 Count
1789941854	83 Count	933 Count	49 Count
1789940085	78 Count	930 Count	49 Count
1789938285	76 Count	901 Count	48 Count
1789936484	74 Count	876 Count	47 Count
1789934684	72 Count	848 Count	46 Count
1789932883	69 Count	819 Count	44 Count
1789931082	67 Count	788 Count	43 Count
1789929282	65 Count	762 Count	42 Count
1789927481	62 Count	736 Count	40 Count
1789925681	60 Count	712 Count	39 Count
1789923880	59 Count	678 Count	39 Count
1789922079	58 Count	645 Count	39 Count
1789920279	56 Count	611 Count	38 Count
1789918478	51 Count	574 Count	35 Count
1789916677	35 Count	510 Count	20 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)