N6QP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N6QP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1773116935	12.53 Volt	100 Pcnt
1773116635	12.53 Volt	100 Pcnt
1773116335	12.53 Volt	100 Pcnt
1773116035	12.53 Volt	100 Pcnt
1773115735	12.53 Volt	100 Pcnt
1773115435	12.53 Volt	100 Pcnt
1773115135	12.53 Volt	100 Pcnt
1773114835	12.53 Volt	100 Pcnt
1773114535	12.53 Volt	100 Pcnt
1773114235	12.53 Volt	100 Pcnt
1773113935	12.53 Volt	100 Pcnt
1773113635	12.53 Volt	100 Pcnt
1773113335	12.53 Volt	100 Pcnt
1773113035	12.53 Volt	100 Pcnt
1773112735	12.53 Volt	100 Pcnt
1773112435	12.53 Volt	100 Pcnt
1773112135	12.53 Volt	100 Pcnt
1773111835	12.53 Volt	100 Pcnt
1773111535	12.53 Volt	0 Pcnt
1773111235	12.53 Volt	0 Pcnt
1773110935	12.53 Volt	0 Pcnt
1773110635	12.53 Volt	0 Pcnt
1773110335	12.53 Volt	0 Pcnt
1773110035	12.53 Volt	0 Pcnt
1773109735	12.53 Volt	0 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)