DB0CRE-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0CRE-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1788596377	0 C deg	20.2 C deg
1788594547	0 C deg	20.1 C deg
1788592769	0 C deg	19.2 C deg
1788592717	0 C deg	19.2 C deg
1788590887	0 C deg	15.8 C deg
1788589109	0 C deg	14.1 C deg
1788589057	0 C deg	14.1 C deg
1788587236	0 C deg	13.3 C deg
1788585397	0 C deg	13.1 C deg
1788583566	0 C deg	13.6 C deg
1788581736	0 C deg	12.9 C deg
1788579907	0 C deg	13.3 C deg
1788578076	0 C deg	12.7 C deg
1788576304	0 C deg	12.8 C deg
1788576246	0 C deg	12.8 C deg
1788574416	0 C deg	13.1 C deg
1788572586	0 C deg	13.1 C deg
1788570756	0 C deg	13.2 C deg
1788568926	0 C deg	13.4 C deg
1788567095	0 C deg	13.5 C deg
1788565265	0 C deg	13.5 C deg
1788563435	0 C deg	13.8 C deg
1788561605	0 C deg	14 C deg
1788559775	0 C deg	14.5 C deg
1788558006	0 C deg	14.9 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)