EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784469873	19 Count	198 Count
1784466270	14 Count	152 Count
1784462667	9 Count	111 Count
1784459098	4 Count	64 Count
1784455495	162 Count	1052 Count
1784451892	124 Count	995 Count
1784448289	119 Count	927 Count
1784444686	115 Count	870 Count
1784441083	110 Count	815 Count
1784437480	105 Count	755 Count
1784433877	100 Count	695 Count
1784430274	95 Count	639 Count
1784426671	90 Count	567 Count
1784423068	85 Count	502 Count
1784419465	80 Count	445 Count
1784415899	75 Count	396 Count
1784412295	58 Count	337 Count
1784408693	54 Count	272 Count
1784405090	33 Count	208 Count
1784401487	19 Count	137 Count
1784397883	9 Count	59 Count
1784394280	95 Count	1003 Count
1784390677	89 Count	938 Count
1784387074	84 Count	882 Count
1784383472	77 Count	817 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)