DB0BC-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DB0BC-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Volt*	Ampere*
1780547331	12.6 V	2524 A
1780545518	12.6 V	2441 A
1780543703	12.6 V	3020 A
1780541892	12.6 V	2407 A
1780540072	12.6 V	2372 A
1780538258	12.6 V	2664 A
1780536442	12.6 V	2388 A
1780534628	12.5 V	3093 A
1780532812	12.6 V	2409 A
1780530998	12.6 V	2419 A
1780529183	12.6 V	2814 A
1780527365	12.6 V	2535 A
1780525557	12.6 V	2476 A
1780523738	12.6 V	2466 A
1780521923	12.6 V	2421 A
1780520104	12.6 V	2429 A
1780516474	12.6 V	2451 A
1780514658	12.6 V	2491 A
1780512847	12.6 V	2498 A
1780509217	12.6 V	2756 A
1780502128	12.6 V	2461 A
1780498326	12.6 V	2507 A
1780489249	12.6 V	2585 A
1780483803	12.6 V	2528 A
1780481988	12.6 V	2518 A

*Used Equation Coefficients:

Volt: 0, 1, 0

Ampere: 0, 1, 0

Batt: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)