IT9EWK-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9EWK-14. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757938365	52 Count	369 Count
1757934757	50 Count	353 Count
1757932954	49 Count	347 Count
1757931150	48 Count	339 Count
1757929346	47 Count	333 Count
1757927543	46 Count	325 Count
1757925738	45 Count	314 Count
1757923935	44 Count	308 Count
1757917399	39 Count	308 Count
1757915615	38 Count	300 Count
1757913791	37 Count	291 Count
1757912031	32 Count	282 Count
1757910227	31 Count	274 Count
1757908423	30 Count	265 Count
1757906620	29 Count	256 Count
1757904816	28 Count	246 Count
1757903012	27 Count	236 Count
1757901209	26 Count	220 Count
1757899405	25 Count	211 Count
1757897601	24 Count	201 Count
1757895797	23 Count	191 Count
1757893994	22 Count	174 Count
1757892190	21 Count	153 Count
1757886830	14 Count	132 Count
1757885026	13 Count	122 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)