LZ1PDB-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LZ1PDB-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temperatu*	Pressure*
1753495262	33 °C	951 hPa
1753494655	33 °C	951 hPa
1753494055	33 °C	951 hPa
1753493455	33 °C	951 hPa
1753492855	33 °C	951 hPa
1753492255	33 °C	951 hPa
1753491655	34 °C	951 hPa
1753491055	34 °C	951 hPa
1753490455	34 °C	951 hPa
1753489855	34 °C	951 hPa
1753489255	34 °C	951 hPa
1753488655	34 °C	951 hPa
1753488055	35 °C	951 hPa
1753487455	35 °C	951 hPa
1753486855	35 °C	951 hPa
1753486255	35 °C	951 hPa
1753485655	35 °C	951 hPa
1753485054	36 °C	951 hPa
1753483855	36 °C	951 hPa
1753483254	36 °C	951 hPa
1753482654	37 °C	950 hPa
1753482055	37 °C	950 hPa
1753481455	37 °C	950 hPa
1753480854	37 °C	950 hPa
1753480254	37 °C	950 hPa

*Used Equation Coefficients:

Temperatu: 0, 1, 0

Pressure: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)