IZ2XCK-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2XCK-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1788555288	12.9 Volt	-64 C
1788554388	12.9 Volt	-64 C
1788553788	12.9 Volt	-64 C
1788553188	12.9 Volt	-64 C
1788552288	12.9 Volt	-64 C
1788551988	12.9 Volt	-64 C
1788551688	12.9 Volt	-64 C
1788551388	12.9 Volt	-64 C
1788551088	12.9 Volt	-64 C
1788550788	12.9 Volt	-64 C
1788550488	12.9 Volt	-64 C
1788549588	12.9 Volt	-64 C
1788549288	12.9 Volt	-64 C
1788548388	12.9 Volt	-64 C
1788548088	12.9 Volt	-64 C
1788547788	12.9 Volt	-64 C
1788547488	12.9 Volt	-64 C
1788547188	12.9 Volt	-64 C
1788546888	12.9 Volt	-64 C
1788546588	12.98 Volt	-64 C
1788545988	12.9 Volt	-64 C
1788545688	12.9 Volt	-64 C
1788545388	12.9 Volt	-64 C
1788545088	12.9 Volt	-64 C
1788544788	12.9 Volt	-64 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

A3: 0, 0, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)