SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765514472	815 Count	455 Count	413 Count
1765513569	813 Count	453 Count	412 Count
1765512733	811 Count	452 Count	411 Count
1765511830	809 Count	450 Count	410 Count
1765510927	807 Count	448 Count	409 Count
1765510024	805 Count	446 Count	408 Count
1765509121	803 Count	444 Count	407 Count
1765508218	801 Count	443 Count	406 Count
1765507315	799 Count	441 Count	405 Count
1765506412	797 Count	439 Count	404 Count
1765505509	795 Count	437 Count	403 Count
1765504606	793 Count	436 Count	402 Count
1765503703	791 Count	434 Count	401 Count
1765502800	789 Count	433 Count	400 Count
1765501897	787 Count	431 Count	399 Count
1765500994	785 Count	429 Count	398 Count
1765500091	783 Count	427 Count	397 Count
1765499188	781 Count	426 Count	396 Count
1765498285	779 Count	425 Count	395 Count
1765497382	777 Count	423 Count	394 Count
1765496478	775 Count	422 Count	393 Count
1765495575	773 Count	420 Count	392 Count
1765493770	769 Count	416 Count	390 Count
1765492866	767 Count	415 Count	389 Count
1765491968	765 Count	414 Count	388 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)