OE5RGM-55 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5RGM-55. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1772581257	0 C deg	0.8 C deg
1772579432	0 C deg	0.2 C deg
1772577640	0 C deg	0.9 C deg
1772575802	0 C deg	2.2 C deg
1772573986	0 C deg	1.6 C deg
1772572190	0 C deg	1.3 C deg
1772570357	0 C deg	1.6 C deg
1772568542	0 C deg	1.8 C deg
1772566726	0 C deg	1.8 C deg
1772564912	0 C deg	2.3 C deg
1772563097	0 C deg	2.8 C deg
1772561282	0 C deg	3.4 C deg
1772557662	0 C deg	5.2 C deg
1772555836	0 C deg	7.1 C deg
1772552206	0 C deg	10.2 C deg
1772550391	0 C deg	10.5 C deg
1772548579	0 C deg	13.1 C deg
1772546761	0 C deg	17.7 C deg
1772544946	0 C deg	19.8 C deg
1772541322	0 C deg	22.4 C deg
1772539501	0 C deg	22.3 C deg
1772537694	0 C deg	17.5 C deg
1772535877	0 C deg	19.3 C deg
1772534056	0 C deg	16.4 C deg
1772532241	0 C deg	17.1 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)