SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789970794	258 Count	767 Count	232 Count
1789968991	226 Count	699 Count	201 Count
1789967213	200 Count	652 Count	180 Count
1789965412	184 Count	610 Count	165 Count
1789963612	163 Count	560 Count	145 Count
1789961811	149 Count	523 Count	132 Count
1789960010	135 Count	493 Count	119 Count
1789958209	110 Count	448 Count	95 Count
1789956408	99 Count	411 Count	85 Count
1789954608	90 Count	373 Count	77 Count
1789952807	81 Count	340 Count	69 Count
1789951006	69 Count	301 Count	58 Count
1789949206	57 Count	263 Count	47 Count
1789947405	44 Count	209 Count	36 Count
1789939348	39 Count	209 Count	36 Count
1789937547	30 Count	154 Count	28 Count
1789935747	18 Count	96 Count	17 Count
1789933946	8 Count	46 Count	8 Count
1789932145	316 Count	1013 Count	287 Count
1789930344	308 Count	971 Count	280 Count
1789928544	296 Count	921 Count	269 Count
1789926743	287 Count	877 Count	261 Count
1789924942	266 Count	822 Count	241 Count
1789923141	233 Count	744 Count	209 Count
1789921341	208 Count	678 Count	185 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)