SP6RJ-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RJ-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784675099	873 Count	170 Count	169 Count
1784673890	866 Count	170 Count	169 Count
1784673286	863 Count	170 Count	169 Count
1784672683	860 Count	170 Count	169 Count
1784672080	857 Count	170 Count	169 Count
1784671477	854 Count	170 Count	169 Count
1784670874	851 Count	170 Count	169 Count
1784670271	848 Count	170 Count	169 Count
1784669668	845 Count	170 Count	169 Count
1784669065	842 Count	170 Count	169 Count
1784668462	839 Count	170 Count	169 Count
1784667858	836 Count	170 Count	169 Count
1784667255	833 Count	170 Count	169 Count
1784666653	830 Count	170 Count	169 Count
1784666049	827 Count	170 Count	169 Count
1784665446	824 Count	170 Count	169 Count
1784664240	818 Count	170 Count	169 Count
1784663637	815 Count	170 Count	169 Count
1784661828	806 Count	170 Count	169 Count
1784661225	803 Count	170 Count	169 Count
1784660831	797 Count	170 Count	169 Count
1784660743	792 Count	170 Count	169 Count
1784660377	785 Count	170 Count	169 Count
1784659775	782 Count	170 Count	169 Count
1784659171	779 Count	170 Count	169 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)