HB9IMG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9IMG. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785296751	641 Count	368 Count	361 Count
1785294948	636 Count	364 Count	357 Count
1785293144	630 Count	359 Count	352 Count
1785291341	625 Count	355 Count	348 Count
1785289537	622 Count	353 Count	346 Count
1785287772	613 Count	349 Count	342 Count
1785285969	611 Count	348 Count	341 Count
1785284166	608 Count	346 Count	339 Count
1785282362	606 Count	345 Count	338 Count
1785280559	605 Count	345 Count	338 Count
1785278755	604 Count	345 Count	338 Count
1785276952	602 Count	344 Count	337 Count
1785273345	600 Count	344 Count	337 Count
1785271542	599 Count	344 Count	337 Count
1785269738	598 Count	344 Count	337 Count
1785264366	589 Count	342 Count	335 Count
1785262563	587 Count	341 Count	334 Count
1785260760	584 Count	339 Count	332 Count
1785257153	580 Count	337 Count	330 Count
1785255350	579 Count	337 Count	330 Count
1785253546	578 Count	337 Count	330 Count
1785249939	576 Count	337 Count	330 Count
1785248135	574 Count	336 Count	329 Count
1785246342	573 Count	336 Count	329 Count
1785244566	568 Count	336 Count	329 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)