F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784722353	761 Count	181 Count	143 Count
1784721389	760 Count	181 Count	143 Count
1784720425	759 Count	181 Count	143 Count
1784719461	758 Count	181 Count	143 Count
1784718497	757 Count	181 Count	143 Count
1784717533	756 Count	181 Count	143 Count
1784716569	755 Count	181 Count	143 Count
1784715605	754 Count	181 Count	143 Count
1784714641	753 Count	181 Count	143 Count
1784713677	752 Count	181 Count	143 Count
1784712713	751 Count	181 Count	143 Count
1784711749	750 Count	181 Count	143 Count
1784710785	749 Count	181 Count	143 Count
1784709821	748 Count	181 Count	143 Count
1784708857	747 Count	181 Count	143 Count
1784707893	746 Count	181 Count	143 Count
1784706929	745 Count	181 Count	143 Count
1784705965	744 Count	181 Count	143 Count
1784705573	743 Count	181 Count	143 Count
1784704609	742 Count	181 Count	143 Count
1784703645	741 Count	181 Count	143 Count
1784702681	740 Count	181 Count	143 Count
1784701717	739 Count	181 Count	143 Count
1784700753	738 Count	181 Count	143 Count
1784699789	737 Count	181 Count	143 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)