SQ1JKB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ1JKB-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780583403	343 Count	29 Count	29 Count
1780581602	342 Count	29 Count	29 Count
1780579802	341 Count	29 Count	29 Count
1780578001	340 Count	29 Count	29 Count
1780576200	339 Count	29 Count	29 Count
1780574400	338 Count	29 Count	29 Count
1780572599	337 Count	29 Count	29 Count
1780570799	336 Count	29 Count	29 Count
1780568998	335 Count	29 Count	29 Count
1780567197	334 Count	29 Count	29 Count
1780565397	333 Count	29 Count	29 Count
1780563596	332 Count	29 Count	29 Count
1780561803	331 Count	29 Count	29 Count
1780560002	330 Count	29 Count	29 Count
1780558202	329 Count	29 Count	29 Count
1780556401	328 Count	29 Count	29 Count
1780554600	327 Count	29 Count	29 Count
1780552800	326 Count	29 Count	29 Count
1780550998	325 Count	29 Count	29 Count
1780549197	324 Count	29 Count	29 Count
1780547397	323 Count	29 Count	29 Count
1780545596	322 Count	29 Count	29 Count
1780543795	321 Count	29 Count	29 Count
1780541995	320 Count	29 Count	29 Count
1780540201	319 Count	29 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)