IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761552150	11 Count	371 Count
1761548538	9 Count	321 Count
1761544930	7 Count	245 Count
1761541322	5 Count	187 Count
1761537765	3 Count	116 Count
1761534156	1 Count	58 Count
1761530548	29 Count	1012 Count
1761526940	27 Count	961 Count
1761523332	25 Count	909 Count
1761519724	23 Count	861 Count
1761516161	21 Count	813 Count
1761512553	19 Count	762 Count
1761508945	17 Count	700 Count
1761505337	15 Count	640 Count
1761501729	13 Count	547 Count
1761498121	11 Count	436 Count
1761494564	9 Count	385 Count
1761490956	7 Count	329 Count
1761476523	27 Count	975 Count
1761472960	25 Count	867 Count
1761469352	23 Count	759 Count
1761462135	19 Count	627 Count
1761458527	17 Count	563 Count
1761454919	15 Count	504 Count
1761451363	13 Count	443 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)