YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789946143	17 Count	249 Count
1789925754	16 Count	249 Count
1789923950	15 Count	235 Count
1789922146	14 Count	218 Count
1789920342	13 Count	203 Count
1789918538	12 Count	186 Count
1789916735	11 Count	169 Count
1789914931	10 Count	156 Count
1789913127	9 Count	140 Count
1789911323	8 Count	129 Count
1789909512	7 Count	120 Count
1789907708	6 Count	105 Count
1789905945	5 Count	91 Count
1789904141	4 Count	74 Count
1789902337	3 Count	58 Count
1789900533	2 Count	45 Count
1789898729	1 Count	30 Count
1789896925	0 Count	14 Count
1789895121	75 Count	1008 Count
1789893317	74 Count	991 Count
1789891513	73 Count	977 Count
1789889709	72 Count	961 Count
1789887905	71 Count	944 Count
1789886101	70 Count	931 Count
1789884344	69 Count	914 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)