SQ2LXR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2LXR-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1765568421	892 Count	260 Count
1765568361	891 Count	260 Count
1765568301	890 Count	259 Count
1765568241	889 Count	259 Count
1765568180	889 Count	259 Count
1765568120	885 Count	258 Count
1765568060	881 Count	257 Count
1765568000	881 Count	257 Count
1765567940	881 Count	257 Count
1765567880	881 Count	257 Count
1765567824	881 Count	257 Count
1765567760	881 Count	257 Count
1765567700	875 Count	255 Count
1765567640	874 Count	255 Count
1765567580	872 Count	254 Count
1765567519	872 Count	254 Count
1765567459	871 Count	254 Count
1765567399	871 Count	254 Count
1765567339	871 Count	254 Count
1765567279	871 Count	254 Count
1765567219	868 Count	253 Count
1765567159	864 Count	252 Count
1765567114	862 Count	251 Count
1765567039	861 Count	251 Count
1765566978	861 Count	251 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)