SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787585337	51 Count	906 Count
1787584436	50 Count	901 Count
1787583535	49 Count	873 Count
1787582634	48 Count	843 Count
1787581734	47 Count	819 Count
1787580833	46 Count	806 Count
1787579932	45 Count	793 Count
1787579031	44 Count	773 Count
1787578148	43 Count	761 Count
1787577247	42 Count	734 Count
1787576346	41 Count	701 Count
1787575446	40 Count	663 Count
1787574545	39 Count	641 Count
1787573644	38 Count	613 Count
1787572743	37 Count	567 Count
1787570941	35 Count	546 Count
1787570040	34 Count	537 Count
1787569139	33 Count	517 Count
1787568239	32 Count	489 Count
1787567338	31 Count	467 Count
1787566437	30 Count	448 Count
1787565536	29 Count	436 Count
1787564636	28 Count	414 Count
1787563735	27 Count	403 Count
1787562834	26 Count	397 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)