This is the latest recevied telemetry packets stored in our database for station/object IZ2PAG-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Temp*
A3*
A4*
A5*
1789965371
12.83 Volt
-64 C
0 None
0 None
0 None
1789877568
12.38 Volt
-64 C
0 None
0 None
0 None
1789852486
13.58 Volt
-64 C
0 None
0 None
0 None
1789852186
14.33 Volt
-64 C
0 None
0 None
0 None
1789850248
12.98 Volt
-64 C
0 None
0 None
0 None
1789844664
14.33 Volt
-64 C
0 None
0 None
0 None
1789844372
12.75 Volt
-64 C
0 None
0 None
0 None
1789814576
14.33 Volt
-64 C
0 None
0 None
0 None
1789813376
14.33 Volt
-64 C
0 None
0 None
0 None
1789801501
12.98 Volt
-64 C
0 None
0 None
0 None
1789801202
12.98 Volt
-64 C
0 None
0 None
0 None
1789800593
12.98 Volt
-64 C
0 None
0 None
0 None
1789800293
12.53 Volt
-64 C
0 None
0 None
0 None
1789799093
12.98 Volt
-64 C
0 None
0 None
0 None
1789798730
14.48 Volt
-64 C
0 None
0 None
0 None
1789798430
14.4 Volt
-64 C
0 None
0 None
0 None
1789798130
14.4 Volt
-64 C
0 None
0 None
0 None
*Used Equation Coefficients:
Vin: 0, 0.075, 0
Temp: 0, 0.5, -64
A3: 0, 0, 0
A4: 0, 0, 0
A5: 0, 0, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)