SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789969831	95 Count	97 Count
1789969230	94 Count	96 Count
1789968629	93 Count	95 Count
1789968028	92 Count	94 Count
1789966827	90 Count	92 Count
1789966226	89 Count	91 Count
1789965625	88 Count	90 Count
1789965024	87 Count	89 Count
1789964423	86 Count	88 Count
1789963822	85 Count	87 Count
1789963221	84 Count	86 Count
1789962620	83 Count	85 Count
1789962020	82 Count	84 Count
1789961419	81 Count	83 Count
1789960818	80 Count	82 Count
1789960217	79 Count	81 Count
1789959616	78 Count	80 Count
1789959016	77 Count	79 Count
1789958415	76 Count	78 Count
1789957815	75 Count	77 Count
1789957256	74 Count	76 Count
1789956612	73 Count	75 Count
1789956012	72 Count	74 Count
1789955411	71 Count	73 Count
1789954839	66 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)