SP3DVO-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753926877	130 Count	64 Count	64 Count
1753925076	129 Count	64 Count	64 Count
1753923276	128 Count	64 Count	64 Count
1753921475	127 Count	64 Count	64 Count
1753919674	126 Count	64 Count	64 Count
1753917874	125 Count	64 Count	64 Count
1753916073	124 Count	64 Count	64 Count
1753914273	123 Count	64 Count	64 Count
1753912472	122 Count	64 Count	64 Count
1753910671	121 Count	64 Count	64 Count
1753908871	120 Count	64 Count	64 Count
1753905276	118 Count	64 Count	64 Count
1753903475	117 Count	64 Count	64 Count
1753901675	116 Count	64 Count	64 Count
1753899874	97 Count	46 Count	46 Count
1753898074	96 Count	46 Count	46 Count
1753896273	85 Count	36 Count	36 Count
1753894472	84 Count	36 Count	36 Count
1753892672	83 Count	36 Count	36 Count
1753890871	82 Count	36 Count	36 Count
1753889071	81 Count	36 Count	36 Count
1753887270	80 Count	36 Count	36 Count
1753883675	78 Count	36 Count	36 Count
1753881875	77 Count	36 Count	36 Count
1753880087	76 Count	36 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)