This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
TX*
RX*
Digi*
V_Bat*
V_Ext*
1784569280
13 Count
11 Count
11 Count
4.14 VDC
0.14 VDC
1784567475
7 Count
7 Count
7 Count
4.17 VDC
0.14 VDC
1784565669
992 Count
179 Count
179 Count
4.19 VDC
0.14 VDC
1784563863
979 Count
168 Count
168 Count
4.13 VDC
0.14 VDC
1784562059
968 Count
159 Count
159 Count
4.21 VDC
0.14 VDC
1784560252
953 Count
146 Count
146 Count
4.15 VDC
0.14 VDC
1784558446
949 Count
144 Count
144 Count
4.2 VDC
0.14 VDC
1784556641
947 Count
144 Count
144 Count
4.11 VDC
0.14 VDC
1784554835
944 Count
143 Count
143 Count
4.12 VDC
0.14 VDC
1784553029
936 Count
137 Count
137 Count
4.19 VDC
0.14 VDC
1784551223
928 Count
131 Count
131 Count
4.23 VDC
0.14 VDC
1784311730
922 Count
131 Count
131 Count
4.11 VDC
0.14 VDC
1784309925
920 Count
131 Count
131 Count
4.18 VDC
0.14 VDC
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)