SP8C-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787586918	828 Count	842 Count	828 Count
1787585118	822 Count	836 Count	822 Count
1787583318	822 Count	836 Count	822 Count
1787581518	802 Count	816 Count	802 Count
1787579718	800 Count	814 Count	800 Count
1787577918	800 Count	814 Count	800 Count
1787576117	800 Count	814 Count	800 Count
1787574324	800 Count	814 Count	800 Count
1787572524	800 Count	814 Count	800 Count
1787570858	800 Count	814 Count	800 Count
1787568923	800 Count	814 Count	800 Count
1787567123	800 Count	814 Count	800 Count
1787565323	800 Count	814 Count	800 Count
1787563523	800 Count	814 Count	800 Count
1787561807	800 Count	814 Count	800 Count
1787559923	800 Count	814 Count	800 Count
1787558122	800 Count	814 Count	800 Count
1787556322	800 Count	814 Count	800 Count
1787554522	800 Count	814 Count	800 Count
1787552722	800 Count	814 Count	800 Count
1787550922	800 Count	814 Count	800 Count
1787549121	797 Count	811 Count	797 Count
1787547390	783 Count	797 Count	783 Count
1787545521	772 Count	786 Count	772 Count
1787543721	772 Count	786 Count	772 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)