LU6MHO-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU6MHO-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1774528363	584 Count	28 Count	11 Count
1774527462	583 Count	28 Count	11 Count
1774526573	582 Count	28 Count	11 Count
1774525661	581 Count	28 Count	11 Count
1774524760	580 Count	28 Count	11 Count
1774523860	579 Count	28 Count	11 Count
1774522959	578 Count	28 Count	11 Count
1774522058	577 Count	28 Count	11 Count
1774521190	576 Count	28 Count	11 Count
1774520257	575 Count	28 Count	11 Count
1774519372	574 Count	28 Count	11 Count
1774518471	573 Count	28 Count	11 Count
1774517570	572 Count	28 Count	11 Count
1774516670	571 Count	28 Count	11 Count
1774515769	570 Count	28 Count	11 Count
1774514868	569 Count	28 Count	11 Count
1774513968	568 Count	28 Count	11 Count
1774513067	567 Count	28 Count	11 Count
1774512166	566 Count	28 Count	11 Count
1774511266	565 Count	28 Count	11 Count
1774510365	564 Count	28 Count	11 Count
1774509464	563 Count	28 Count	11 Count
1774508564	562 Count	28 Count	11 Count
1774507663	561 Count	28 Count	11 Count
1774506762	560 Count	28 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)