PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773146494	95 Count	415 Count
1773142891	94 Count	412 Count
1773139290	93 Count	410 Count
1773135685	92 Count	408 Count
1773132093	91 Count	406 Count
1773128490	90 Count	399 Count
1773124887	89 Count	397 Count
1773121285	88 Count	395 Count
1773117685	87 Count	393 Count
1773114079	86 Count	391 Count
1773110492	85 Count	389 Count
1773106889	84 Count	382 Count
1773103286	83 Count	380 Count
1773099683	82 Count	378 Count
1773096080	81 Count	376 Count
1773088896	79 Count	372 Count
1773085289	78 Count	365 Count
1773081686	77 Count	363 Count
1773078082	76 Count	361 Count
1773074479	75 Count	359 Count
1773070880	74 Count	357 Count
1773067292	73 Count	355 Count
1773063689	72 Count	306 Count
1773060086	71 Count	304 Count
1773045691	67 Count	296 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)