UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781419255	218 Count	623 Count	145 Count
1781418350	215 Count	614 Count	143 Count
1781417444	212 Count	606 Count	141 Count
1781416539	209 Count	597 Count	139 Count
1781415633	206 Count	589 Count	137 Count
1781414728	203 Count	579 Count	135 Count
1781413823	200 Count	571 Count	133 Count
1781412917	197 Count	561 Count	131 Count
1781412012	194 Count	554 Count	129 Count
1781411239	191 Count	546 Count	127 Count
1781410333	188 Count	537 Count	125 Count
1781409428	185 Count	528 Count	123 Count
1781408522	182 Count	521 Count	121 Count
1781407616	179 Count	512 Count	119 Count
1781406711	176 Count	503 Count	117 Count
1781405805	173 Count	492 Count	115 Count
1781404900	170 Count	483 Count	113 Count
1781403994	167 Count	471 Count	111 Count
1781403089	164 Count	463 Count	109 Count
1781402183	161 Count	457 Count	107 Count
1781401277	158 Count	444 Count	105 Count
1781400372	155 Count	436 Count	103 Count
1781399466	152 Count	427 Count	101 Count
1781398561	149 Count	422 Count	99 Count
1781397655	146 Count	413 Count	97 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)