PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784680148	963 Count	555 Count	512 Count
1784678345	962 Count	555 Count	512 Count
1784676541	961 Count	555 Count	512 Count
1784674737	960 Count	555 Count	512 Count
1784672934	959 Count	555 Count	512 Count
1784671130	958 Count	555 Count	512 Count
1784669367	953 Count	555 Count	512 Count
1784667564	952 Count	555 Count	512 Count
1784665760	951 Count	555 Count	512 Count
1784663956	950 Count	555 Count	512 Count
1784662153	949 Count	555 Count	512 Count
1784660349	948 Count	555 Count	512 Count
1784658545	947 Count	555 Count	512 Count
1784656742	946 Count	555 Count	512 Count
1784654938	945 Count	555 Count	512 Count
1784653134	944 Count	555 Count	512 Count
1784651331	943 Count	555 Count	512 Count
1784649527	942 Count	555 Count	512 Count
1784647765	937 Count	555 Count	512 Count
1784645961	936 Count	555 Count	512 Count
1784644157	935 Count	555 Count	512 Count
1784642354	930 Count	551 Count	508 Count
1784640551	929 Count	551 Count	508 Count
1784638746	928 Count	551 Count	508 Count
1784636942	919 Count	543 Count	500 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)