DL5BIT-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL5BIT-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	VBatt*	Temp*
1788023850	13.2 Volt	29.5 C
1788022950	13.43 Volt	30 C
1788022050	13.43 Volt	30 C
1788021151	13.5 Volt	30 C
1788020250	13.73 Volt	30 C
1788019350	13.5 Volt	30.5 C
1788018450	13.5 Volt	30.5 C
1788017550	13.43 Volt	31 C
1788016650	13.5 Volt	31 C
1788015750	13.65 Volt	31 C
1788014850	13.65 Volt	31 C
1788013950	13.43 Volt	31 C
1788013050	13.43 Volt	31 C
1788012150	13.35 Volt	31 C
1788011250	13.88 Volt	30.5 C
1788010350	13.73 Volt	29.5 C
1788009450	14.48 Volt	29 C
1788008550	14.48 Volt	28 C
1788007650	14.48 Volt	28 C
1788006750	14.48 Volt	28 C
1788005850	14.48 Volt	27.5 C
1788003150	14.03 Volt	30 C
1788002250	14.1 Volt	29.5 C
1788000450	14.4 Volt	27 C
1787999550	14.48 Volt	27.5 C

*Used Equation Coefficients:

VBatt: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)