This is the latest recevied telemetry packets stored in our database for station/object DIGHTN-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Vin*
Rx1h*
Dg1h*
Eff1h*
A5*
1753616542
14.33 Volt
1710 Pkt
1710 Pkt
79 Pcnt
0 None
1753600324
14.33 Volt
560 Pkt
560 Pkt
64 Pcnt
0 None
1753537265
14.33 Volt
1870 Pkt
1870 Pkt
72 Pcnt
0 None
1753102164
14.33 Volt
880 Pkt
880 Pkt
82 Pcnt
0 None
1753100355
14.33 Volt
1100 Pkt
1100 Pkt
86 Pcnt
0 None
1753098561
14.25 Volt
810 Pkt
810 Pkt
86 Pcnt
0 None
*Used Equation Coefficients:
Vin: 0, 0.075, 0
Rx1h: 0, 10, 0
Dg1h: 0, 10, 0
Eff1h: 0, 1, 0
A5: 0, 0, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)