SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789960999	484 Count	562 Count	35 Count
1789960398	483 Count	561 Count	35 Count
1789959797	482 Count	560 Count	35 Count
1789959196	481 Count	559 Count	35 Count
1789958595	480 Count	558 Count	35 Count
1789957994	479 Count	557 Count	35 Count
1789957393	478 Count	556 Count	35 Count
1789956793	477 Count	555 Count	35 Count
1789956192	476 Count	554 Count	35 Count
1789955591	475 Count	553 Count	35 Count
1789954990	474 Count	547 Count	35 Count
1789954389	473 Count	546 Count	35 Count
1789953788	472 Count	545 Count	35 Count
1789953187	471 Count	544 Count	35 Count
1789952586	470 Count	543 Count	35 Count
1789951986	469 Count	542 Count	35 Count
1789951385	468 Count	541 Count	35 Count
1789950784	467 Count	540 Count	35 Count
1789950183	466 Count	539 Count	35 Count
1789949583	465 Count	538 Count	35 Count
1789949012	460 Count	537 Count	35 Count
1789948412	459 Count	536 Count	35 Count
1789947811	458 Count	535 Count	35 Count
1789947210	457 Count	534 Count	35 Count
1789946609	456 Count	533 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)