PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788614450	319 Count	711 Count
1788612646	318 Count	708 Count
1788610843	317 Count	705 Count
1788609040	316 Count	702 Count
1788607236	315 Count	699 Count
1788605433	314 Count	696 Count
1788603629	313 Count	693 Count
1788601826	312 Count	690 Count
1788600023	311 Count	687 Count
1788598219	310 Count	684 Count
1788596454	305 Count	681 Count
1788594651	304 Count	678 Count
1788592847	303 Count	675 Count
1788591056	302 Count	672 Count
1788589247	301 Count	669 Count
1788587455	300 Count	666 Count
1788585634	299 Count	663 Count
1788583830	298 Count	660 Count
1788582027	297 Count	657 Count
1788580223	296 Count	654 Count
1788578420	295 Count	651 Count
1788576617	294 Count	648 Count
1788574851	289 Count	645 Count
1788573047	288 Count	642 Count
1788571244	287 Count	639 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)