SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777595350	406 Count	69 Count	7 Count
1777593555	401 Count	69 Count	7 Count
1777591754	400 Count	69 Count	7 Count
1777589954	399 Count	69 Count	7 Count
1777588153	398 Count	69 Count	7 Count
1777586352	397 Count	69 Count	7 Count
1777577350	392 Count	64 Count	7 Count
1777575549	391 Count	64 Count	7 Count
1777568353	383 Count	61 Count	7 Count
1777530546	358 Count	58 Count	7 Count
1777528751	353 Count	58 Count	7 Count
1777526951	352 Count	58 Count	7 Count
1777525150	351 Count	58 Count	7 Count
1777523350	350 Count	58 Count	7 Count
1777521549	349 Count	58 Count	7 Count
1777519749	348 Count	58 Count	7 Count
1777517948	347 Count	58 Count	7 Count
1777516148	346 Count	58 Count	7 Count
1777514347	345 Count	58 Count	7 Count
1777512546	344 Count	58 Count	7 Count
1777510746	343 Count	58 Count	7 Count
1777508945	342 Count	58 Count	7 Count
1777507150	337 Count	58 Count	7 Count
1777505350	336 Count	58 Count	7 Count
1777501749	334 Count	58 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)