OE3CIN-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE3CIN-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1772660099	12.45 Volt	100 Pcnt
1772659799	12.45 Volt	100 Pcnt
1772659499	12.45 Volt	100 Pcnt
1772659199	12.45 Volt	100 Pcnt
1772658899	12.45 Volt	100 Pcnt
1772658618	12.45 Volt	100 Pcnt
1772658299	12.45 Volt	100 Pcnt
1772657999	12.45 Volt	100 Pcnt
1772657699	12.45 Volt	100 Pcnt
1772657399	12.45 Volt	100 Pcnt
1772657111	12.53 Volt	100 Pcnt
1772656799	12.68 Volt	100 Pcnt
1772656499	12.75 Volt	100 Pcnt
1772656199	12.75 Volt	100 Pcnt
1772655899	12.75 Volt	100 Pcnt
1772655599	12.75 Volt	100 Pcnt
1772655299	12.75 Volt	100 Pcnt
1772654999	12.83 Volt	100 Pcnt
1772654699	12.83 Volt	100 Pcnt
1772654399	13.05 Volt	100 Pcnt
1772654099	13.13 Volt	100 Pcnt
1772653799	13.13 Volt	100 Pcnt
1772653499	13.13 Volt	100 Pcnt
1772653199	13.13 Volt	100 Pcnt
1772652899	12.83 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)