M0KNF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0KNF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1753636063	117 Count	205 Count
1753634263	116 Count	205 Count
1753632463	115 Count	205 Count
1753630663	114 Count	205 Count
1753628863	113 Count	205 Count
1753627060	112 Count	204 Count
1753625257	111 Count	202 Count
1753623489	110 Count	200 Count
1753621686	109 Count	198 Count
1753619883	108 Count	196 Count
1753618080	107 Count	194 Count
1753616277	106 Count	192 Count
1753614474	105 Count	189 Count
1753612670	104 Count	184 Count
1753610867	103 Count	180 Count
1753609064	102 Count	176 Count
1753607261	101 Count	170 Count
1753605458	100 Count	164 Count
1753603655	99 Count	158 Count
1753601888	98 Count	152 Count
1753600085	97 Count	150 Count
1753598282	96 Count	148 Count
1753596479	95 Count	146 Count
1753594676	94 Count	144 Count
1753592873	93 Count	142 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)