OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785283848	790 Count	372 Count	190 Count
1785281921	786 Count	370 Count	188 Count
1785279994	784 Count	370 Count	188 Count
1785278067	782 Count	369 Count	188 Count
1785276141	780 Count	369 Count	188 Count
1785274214	778 Count	369 Count	188 Count
1785252207	746 Count	354 Count	180 Count
1785250280	744 Count	354 Count	180 Count
1785248354	742 Count	354 Count	180 Count
1785246427	740 Count	354 Count	180 Count
1785244500	738 Count	354 Count	180 Count
1785242573	736 Count	354 Count	180 Count
1785240647	734 Count	354 Count	180 Count
1785238720	732 Count	354 Count	180 Count
1785236793	730 Count	354 Count	180 Count
1785234866	728 Count	354 Count	180 Count
1785232940	726 Count	354 Count	180 Count
1785231013	724 Count	354 Count	180 Count
1785230607	723 Count	354 Count	180 Count
1785228680	721 Count	354 Count	180 Count
1785226754	719 Count	354 Count	180 Count
1785224827	717 Count	353 Count	180 Count
1785222900	714 Count	352 Count	179 Count
1785220973	710 Count	350 Count	177 Count
1785219047	707 Count	349 Count	176 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)