SP7TWA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TWA-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788582094	350 Count	589 Count
1788581190	349 Count	588 Count
1788580289	348 Count	586 Count
1788579388	347 Count	585 Count
1788578487	346 Count	583 Count
1788577586	345 Count	581 Count
1788576688	344 Count	579 Count
1788575805	343 Count	578 Count
1788574904	342 Count	576 Count
1788574003	341 Count	574 Count
1788573102	340 Count	572 Count
1788572201	339 Count	571 Count
1788571301	338 Count	569 Count
1788570400	337 Count	568 Count
1788569499	336 Count	565 Count
1788568598	335 Count	564 Count
1788567697	334 Count	561 Count
1788566797	333 Count	560 Count
1788565896	332 Count	558 Count
1788564995	331 Count	556 Count
1788564094	330 Count	554 Count
1788563193	329 Count	553 Count
1788562293	328 Count	551 Count
1788561392	327 Count	550 Count
1788560491	326 Count	548 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)