SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773123651	333 Count	65 Count	24 Count
1773122750	328 Count	65 Count	24 Count
1773121849	323 Count	65 Count	24 Count
1773120949	319 Count	65 Count	24 Count
1773120048	313 Count	65 Count	24 Count
1773119147	309 Count	64 Count	24 Count
1773118246	305 Count	64 Count	24 Count
1773117346	299 Count	63 Count	24 Count
1773116445	283 Count	50 Count	12 Count
1773115544	278 Count	50 Count	12 Count
1773114644	273 Count	49 Count	12 Count
1773113743	268 Count	49 Count	12 Count
1773112842	264 Count	49 Count	12 Count
1773111941	258 Count	49 Count	12 Count
1773111041	254 Count	49 Count	12 Count
1773110140	250 Count	49 Count	12 Count
1773109239	244 Count	49 Count	12 Count
1773108339	240 Count	49 Count	12 Count
1773107441	235 Count	48 Count	12 Count
1773106554	230 Count	47 Count	12 Count
1773105653	226 Count	46 Count	12 Count
1773104752	221 Count	46 Count	12 Count
1773103854	216 Count	45 Count	12 Count
1773102951	211 Count	44 Count	12 Count
1773102050	207 Count	43 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)