EI2EBB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EI2EBB-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1780579973	9.45 Volt	100 Pcnt
1780579972	9.45 Volt	100 Pcnt
1780579673	9.45 Volt	100 Pcnt
1780579672	9.45 Volt	100 Pcnt
1780579389	9.3 Volt	100 Pcnt
1780579373	9.3 Volt	100 Pcnt
1780579072	9.3 Volt	100 Pcnt
1780578773	9.23 Volt	100 Pcnt
1780578772	9.23 Volt	100 Pcnt
1780578473	9.38 Volt	100 Pcnt
1780578472	9.38 Volt	100 Pcnt
1780578172	9.38 Volt	100 Pcnt
1780577873	9.23 Volt	100 Pcnt
1780577872	9.23 Volt	100 Pcnt
1780577573	9.15 Volt	100 Pcnt
1780577572	9.15 Volt	100 Pcnt
1780577273	9.08 Volt	100 Pcnt
1780577272	9.08 Volt	100 Pcnt
1780576973	9.45 Volt	100 Pcnt
1780576972	9.45 Volt	100 Pcnt
1780576673	8.93 Volt	100 Pcnt
1780576672	8.93 Volt	100 Pcnt
1780576373	9.3 Volt	100 Pcnt
1780576372	9.3 Volt	100 Pcnt
1780576073	9.3 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)