SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790081447	76 Count	794 Count
1790078443	74 Count	794 Count
1790073146	73 Count	794 Count
1790072393	72 Count	794 Count
1790072372	71 Count	794 Count
1790072351	70 Count	794 Count
1790071762	69 Count	794 Count
1790070749	67 Count	794 Count
1790070726	66 Count	794 Count
1790069789	65 Count	794 Count
1790066401	64 Count	794 Count
1790066137	63 Count	794 Count
1790065546	62 Count	794 Count
1790065476	61 Count	794 Count
1790065370	60 Count	794 Count
1790065329	59 Count	794 Count
1790065230	58 Count	794 Count
1789995179	57 Count	794 Count
1789994919	56 Count	794 Count
1789992507	54 Count	794 Count
1789992087	53 Count	794 Count
1789992065	52 Count	794 Count
1789991985	51 Count	794 Count
1789991909	49 Count	794 Count
1789991496	47 Count	794 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)